mug heat press transfer machine

IntroductionAny colorful photos, scenery pictures can be transferred printing into coated plates that are particularly suitable for advertising, gifts, promotion, personalized products etc. Simple and quick operation, continuing working ability and highly automatic property, meanwhile the machine can transfer photo onCoated board, coated metal board, coated key ring and coated mirror.

Feature(1) Meter controller makes the heating effect much more steady.(2) Imported silica gel heating pad is able to endure high temperature. To make the pressure more uniform and will not be metamorphosed when the temperature reaches 240°C.(3) Highly electronic resistance equipment which makes the temperature error to be 1°C.(4) Convenient to adjust the pressure with the rolling screw.(5) The biggest transfer size: 8 inch (diameter of the plate)(6) Preheating time ( Room Temperature of 20°C): 1-3 minutes. Temperature status will be showed in the mean while. (7) Fashionable look with small weight makes it flexible to bring with

Operation Process(1)Mirror print the picture on normal printing paper with sublimation ink.Notice: The machine should be connected with ground wire! Should not have much pressure on the machine, otherwise the heating pad will be metamorphosed. Make sure the size of the photo is the same with the surface of the plate while putting the photo onto the plate.(2)Put the picture onto the plate (3)Put the plate on the middle part of the plate holder(4)Adjust the pressure with the rolling screw under the plate holder(5)Hold the plate and press the handle(6)Set up the heating temperature to 180°C (7)Set up the heating time to 30 s(8)Switch on power. (Power indicator will turn on green)(9)Waiting until the temperature reach to 180°C ( temperature indicator will turn on red )(10)Switch on timer for heat transferring (11)Warning automatically after 30 s(12)Switch the power off(13)Stretch the handle to open the holder and then take out the plate(14)Finished photo transferring on plate

Accessories (1)The Printer. Choose any normal Inkjet photo printer and Epson series printer is recommended.(2)To achieve the best quality of the photo printing, the following printer setting for your reference:a.Choose the “Best Photo” and the “Photo Quality Ink Jet Paper” under “Main” as shown in figure 1. b.Click “Advanced” under “Main” to achieve more setting as shown in figure 2.c.Choose “Mirror Image” under “ Page Layout” as shown in figure 3 while printing photo for ceramic board and metal board, shell board and imitative ceramic necklace etc.

1.Light weight and portable, for use at malls, flea markets, shows etc. 2.Fully digital temperature control 3.Automatic digital timer 4.No limit on height of mug,could turn left and right,choose the most suitable place to print 5.Be able to bear high temperature with silica gel,press equal.

6.Easy pressure adjustment ,Solid steel welded framework 7.Soft heater liner for accommodating inconsistent mugs

Size (L W H)  31X28.8X27.5cmNet Weight  9KgGross Weight  10KgVoltage 110V/ 220V

Power  300WTemperature Range  0-220°CTiming Range  0-999 Sec.Pressing Size   Diameter 7.5~9.5cm  or  5.0-7.0cm

The operation processStep1: Place the print face down on the mug and secure it with thermally resistant tape. Place the tape on opposite ends of the print. Step2: Slide the mug into the mug press and apply pressure. Fifteen to twenty seconds later after the temperature reaches 180°C, remove the mug from the mug press. Step3: Allow the mug to air cool at room temperature. Remove the tape when the mug is cool.